Polycarbonate Flat Lid

VERY simple part, can be produced by means other than milling if it is easier. Material: Clear Polycarbonate The component is mostly flat, 5mm thick, but requires 4 holes at ~3.8mm diameter (tolerance unimportant) and a squared recess of depth 0.75mm, width 1.7mm (tolerance p/m 0.15mm). Avoiding the holes and recess intersecting would be ideal.

hunterannan                                                                                    

1 piece

steel, one piece

Emilian                                                                                    

Shifter Mount Plate

Aluminium, grade unknown, decent strength, use on a car

jumpbike                                                                                    

Rc Car Parts

Looking for a run of about 10 on 3 of the parts and 20 on one part for a start the originally are made in plastic can send them to copy if needed .

SuperRs4                                                                                    

Honeycomb

stainless steel

dapeng (P)                                                                                    

side mounted rotary tattoo machine

6063 aluminium. two parts to it

yurdlum                                                                                    

Mige Motor Mount

I would like a quote for the left panel og my Mige mortor mount

chjensen                                                                                    

parts for test rig

2x TRG-AMB-01-V01, TRG-SLS-01-V01, TRG-FLB-01-V01, TRG-FLB-01-V01, TRG-FLB-02-V01, TRG-FLB-03-V01, TG-FLB-04-V01, TRG-BSB-01-V01, TG-BSS-03-V01, TRG-SEB-01-V01, TRG-SEB-02-V01 4X TRG-AEB-01-V01, TRG-HNG-01-V01, TRG-HNG-02-V01, TRG-HNG-03-V01, TRG-SSB-01-V01 8X TRG-AMB-02-V01

M Wassall (P)                                                                                    

2 x brash bushes for jewellers rolling mill

I require 2 brass bushes to be made to for a hand rolling mill. The bushes are arch shaped pieces and sit on either side of the top roller to keep it from moving. They are approximately 2.5cm x 2.5cm x3cm and have "wings" extending on one face. I can provide a technical drawing with exact measurements and have one actual bush that can be used as a model, although the "wings" have broken off. Please see photos.

HelenC                                                                                    

container for oil

Looking for someone who would be able to weld a container to hold liquid oil inside. 850-1000mm(L)x500-600mm(W) not higher then 250mm (H) - dimensions are nothing critical. Wall thickness anything from 5-25mm. Ideal would be st-st but any steel + coating to protect if from rusting will be fine.

adandrzej